- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone,
Hi first post here.
I apologise but I could not find appropriate sections for CapSense products or Ez-Click 2.0 software.
My question is - I have a number of USB to I2C bridge products from FTDI and microchip (amongst others) does Ez-Click recognise these devices.
In short can I use any old USB to I2C Bridge products and use Ez-Click 2.0 to configure CY8CMBR3xxx range of IC's?
(Please reply and notify me of the correct location for theses products.
Many thanks
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello DoAr_4544041
Cypress recommends using MiniProg3 for configuring MBR3 using Ez-Click. We do not guarantee the working of other parts with Ez-Click and in general, is not recommended.
Thanks and regards
Hari
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello DoAr_4544041
Cypress recommends using MiniProg3 for configuring MBR3 using Ez-Click. We do not guarantee the working of other parts with Ez-Click and in general, is not recommended.
Thanks and regards
Hari