CY8C4125AZI-S413 interface with LCD display

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
hesc_1314511
Level 3
Level 3
10 sign-ins First solution authored 10 replies posted

I made a circuit where a CY8C4125AZI-S413 directly drives an iconographic LCD. The display has normal LCD segments. I tried to make it work and after 15 minutes the CY8C4125AZI-S413 got damaged, it became a short circuit. Is it a problem if CY8C4125AZI-S413 directly drives an LCD dislay with 3.3V?

0 Likes
3 Replies
DheerajK_81
Moderator
Moderator
Moderator
First comment on KBA First comment on blog 5 questions asked

CY8C4125AZI-S413 has the capability to drive an LCD. I don't necessarily think LCD is causing this issue. Can you please send your schematic for review?

Regards,

Dheeraj

0 Likes
lock attach
Attachments are accessible only for community members.

hello,

I attach the scheme of the display

regards

Henry

Il 01/03/2019 08:09, DheerajK_81 ha scritto:

<http://www.cypress.com>

Cypress Developer Community <https://community.cypress.com/?et=watches.email.thread>

CY8C4125AZI-S413 interface with LCD display

reply from DheerajK_81<https://community.cypress.com/people/DheerajK_81?et=watches.email.thread> in PSoC 4 MCU Community - View the full discussion<https://community.cypress.com/message/188813?et=watches.email.thread#188813>

0 Likes

Hello Henry,

I reviewed your schematic. Its not clear what the voltage V12 is and how much voltage arrives at the output (VDD) of the buck regulator (U1). Make sure VDD is between the range 1.8V to 5.5V. Please check this voltage.

Regards,

Dheeraj

0 Likes