- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have made a custom application to CY5670 USB Dongle. Application is a BLE client that also has serial communication link to PC through it's USB interface. All is working OK on my Windows machine. I can read messages and send commands using Teraterm.
It would be important to get similar functionality on my Linux machine as well. When I plug the CY5670 USB Dongle on Linux, there will be no new device nodes on /dev/tty* list (no /dev/ttyACM* that I was expecting to have)
When I give lsusb command it gives following responce:
Bus 008 Device 003: ID 04b4:f139 Cypress Semiconductor Corp.
Could someone advice to make USB/UART bridge functionality to work on Linux?
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't think its supported, Cypress has no Linux drivers 😞 You would need to rogram the PSoC on the dongle with another firmware that behaves as CDC device.