- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am getting the following error(s) when I try to build a project after just completing schematics:
I have already run Update Components, and see that the installed cy_boot version is 5.6. The clock version is 1,2. Both of these fall under
So I assume they are related issues.
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This was a problem of my own making. I tried renaming files within Windows Explorer, rather than within PSOC creator, and I guess I missed a few.
Thanks
Jim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
A couple more questions. The device I am targeting is CYBLE-214009-00. I am curious because the table says this supports only BLE version 4.1, but still BLE version 4.2 is showing up under components tab. There is a CYBLE-214015-01 which is BLE component version 4.2 compatible. but I would rather not use this part due to its lack of availability. I am assuming that the complaint of cy_boot_v4_20 is coincidental with the use of BLE component 4.20, as these are completely different things.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you use the LF_CLK for other things? Or is it complaining when trying to use it for BLE only?
(It could be that Cypress failed to filter the BLE v4.2 from being available/usable)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
(It could be that Cypress failed to filter the BLE v4.2 from being available/usable)
Yes, but I get the same complaint when I point to a BLE v4.2 capable device??
Is the cy_boot the same thing as the radio ble?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
cy_boot is different than the radio BLE; Each one has it's own version. Afaik, the cy_boot is the code that handles interfacing commands/instructions to the underlying ARM chip, and the BLE component is responsible for handling the bluetooth stack/apis/profiles.
Potentially try cleaning, then rebuilding the whole project?
Otherwise, you could messing with the project files to get it to reload the files that are causing issues:
- Create a new project from scratch and see if that causes the same issue
- Delete the offending files, and then reload and try to rebuild the project
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No idea; Haven't seen it before. It might be a PSoC Creator version mismatch issue, or missing/corrupted project files, or corrupted/missing installation files?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This was a problem of my own making. I tried renaming files within Windows Explorer, rather than within PSOC creator, and I guess I missed a few.
Thanks
Jim