- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
When I add an I2C SCB block to my design, I receive a build error. My resources Window does not indicate that I am maxed out on any available components.
I have a feeling it is conflicting with my Soft Uart component. However, if I remove the soft UART, it still will not build. My design worked until I added the I2C block.
Any help would be appreciated.
thanks
--------------- Build Started: 01/16/2020 14:50:49 Project: PSOC_SPM, Configuration: ARM GCC 5.4-2016-q2-update Debug ---------------
cydsfit.exe -.appdatapath "C:\Users\shawng.WAGNER\AppData\Local\Cypress Semiconductor\PSoC Creator\4.2" -.fdsnotice -.fdswarpdepfile=warp_dependencies.txt -.fdselabdepfile=elab_dependencies.txt -.fdsbldfile=generated_files.txt -.fdsreffile=referenced_files.txt -p "C:\Users\shawng.WAGNER\Documents\PSoC Creator\PSOC SPM\PSOC_SPM.cydsn\PSOC_SPM.cyprj" -d CY8C4247AXI-M485 -s "C:\Users\shawng.WAGNER\Documents\PSoC Creator\PSOC SPM\PSOC_SPM.cydsn\Generated_Source\PSoC4" -- -yv2 -q10 -ygs -o0 -v3 -.fftcfgtype=LE
Elaborating Design...
HDL Generation...
Synthesis...
Tech Mapping...
ADD: pft.M0040: information: The following 2 pin(s) will be assigned a location by the fitter: \I2C_Module:scl(0)\, \I2C_Module:sda(0)\
Analog Placement...
Analog Routing...
Analog Code Generation...
Digital Placement...
Digital Routing...
Error: rtr.M0004: E1216: Routing of net __ZERO__ Failed. Source : :udb@[UDB=(1,0)]:pld0:mc1.q, Sink : :m0s8scbcell_0.uart_rx
Error: rtr.M0004: Error routing design: Routing Failed (12)
Dependency Generation...
Cleanup...
Error: fit.M0050: The fitter aborted due to errors, please address all errors and rebuild. (App=cydsfit)
--------------- Build Failed: 01/16/2020 14:50:55 ---------------
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Shawn,
Go to the Build settings> Code Generation > Set Synthesis Optimization Effort to Exhaustive and Build the project again.
Please let me know if this resolves the issue.
Best Regards
Ekta
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Shawn,
Go to the Build settings> Code Generation > Set Synthesis Optimization Effort to Exhaustive and Build the project again.
Please let me know if this resolves the issue.
Best Regards
Ekta
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This worked. Thank you!
Shawn Gerber
Manufacturing Engineer Manager
Wagner Electronic Products Inc.
326 Pine Grove Road
Rogue River, OR 97537
Office: (541) 582-0541 x238
http://www.WagnerMeters.com/<http://www.wagnermeters.com/>