- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have a custom pcb with the PRoC BLE and so far so good... I can debug and program with the MiniProg3 attached via the 5 ways connector.
I just tried the sample code in Cypress AN92584 with this switch set DEEPSLEEP_ONLY... This is supposed to give a good idea about deep sleep current consumption and current leakage. Since I did program this simple app, PSoC Creator doesn't see the target... so I can't program it anymore.
Is there a way to retrieve control of the target? Have I bricked this device?
Any help appreciated...
Cheers
X
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
Quick follow up on that post with some good news: I manage to reprogram the PRoC with the PSoC Programmer tool that I never used.
Basically it didn't want to connect, to program or to power the target for some reason ... and after a lot of tinkering I managed to have 'Powered' field in green (bottom of window) and then just try to program it with the settings in the pic below...
Might come useful to somebody in the same situation as me.
XB