Anonymous
Not applicable
Jun 06, 2017
08:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 06, 2017
08:58 AM
Hi, my question is if I can use the UART v2.50 module with the Bootloader instead of using the SCB module in PSoC 4. I understand I must use the "Custom Interface" option in the Bootloader parameters and the CyBtldrComm* APIs, but I´m no really sure how to use them.
Do I need to write code for the APIs, or is there written code already? Thanks.
2 Replies
Jun 06, 2017
10:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 06, 2017
10:12 AM
You do not need to do anything (nearly). Just place the UART 2.50 and the bootloader components onto the topdesign sheet. Configure the bootloader to use the UART. DONE.
Bob
Anonymous
Not applicable
Jun 06, 2017
11:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 06, 2017
11:01 AM
Thanks Bob, it worked!