cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

New Contributor

Hello all,

I'm contemplating using CYBLE-212019-00 EZ-BLE™ Creator Module and I'm wondering if there are any manufacturing issues in using this module. Specifically, does the module require a no-clean assembly process? I'd prefer to use a clean process, but want to make sure the module does have any restrictions.

Thanks,

0 Likes
Reply
1 Solution
Moderator
Moderator

Hello Andy,

Yes, the PCB containing our module can be washed . Our modules are okay to process through it. But if the board is washed manually, please make sure that the board is not submerged into water for a long period of time ( < 8 mins). If this is done accidentally, then the module needs to be baked after washing.

-Sayani.

View solution in original post

0 Likes
Reply
4 Replies
Moderator
Moderator

Hello,

Please can you elaborate on the specific cleaning process you are asking about?

-Sayani.

0 Likes
Reply
New Contributor

Hello Sayani,

In the words of the manufacturing house:

“It is simply an aqueous (inline) cleaning process, using pure DI water. The machine has a couple hot water spray cycles that clean off the flux, then a couple rinse cycles, then het cycle for drying the boards. Boards are then baked for 30 minutes at 250F for any residual moisture.”

Hope this helps.

Thanks for your reply.

- Andy

0 Likes
Reply
Moderator
Moderator

Hello Andy,

Yes, the PCB containing our module can be washed . Our modules are okay to process through it. But if the board is washed manually, please make sure that the board is not submerged into water for a long period of time ( < 8 mins). If this is done accidentally, then the module needs to be baked after washing.

-Sayani.

View solution in original post

0 Likes
Reply
New Contributor

Hello Sayani,

Perfect. That answers the question. Thank you very much for your time.

- Andy

0 Likes
Reply