Nov 09, 2020
01:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 09, 2020
01:56 AM
Hello,
Please tell me how to enable both RX and TX polarity inversion and Wake up from Deep Sleep mode from UART.
If I set it as shown below, a warning will occur.
Is it needed if I output TX and RX from the terminal once, return it to SmartIO, invert it, and output it again?
Best regards,
Yocchi
Labels
- Labels:
-
PSoC 4 Architecture
0 Replies