cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

JoBr_1593366
Contributor II

In this section of https://www.cypress.com/documentation/technical-reference-manuals/psoc-4200l-family-psoc-4-registers...

it says "Use 0 for EP1, 1 for EP2, etc." under DYN_CONFIG_EN, but DYN_CONFIG_EN is a single enable bit.  Was that supposed to be listed under DYN_RECONFIG_EPNO?

0 Likes
1 Solution
Ekta
Moderator
Moderator

Hello Jonathan,

You are correct that the description listed under DYN_CONFIG_EN should have been under DYN_RECONFIG_EPNO.

To make it clear:

DYN_CONFIG_EN: This bit is used to enable the dynamic re-configuration for the selected EP.

If set to 1, indicates the reconfiguration required for selected EP.

DYN_RECCONFIG_EPNO:  These bits indicates the EP number for which reconfiguration is required when dyn_config_en

bit is set to 1. Use 0 for EP1, 1 for EP2, etc.

Regards

Ekta

View solution in original post

0 Likes
1 Reply
Ekta
Moderator
Moderator

Hello Jonathan,

You are correct that the description listed under DYN_CONFIG_EN should have been under DYN_RECONFIG_EPNO.

To make it clear:

DYN_CONFIG_EN: This bit is used to enable the dynamic re-configuration for the selected EP.

If set to 1, indicates the reconfiguration required for selected EP.

DYN_RECCONFIG_EPNO:  These bits indicates the EP number for which reconfiguration is required when dyn_config_en

bit is set to 1. Use 0 for EP1, 1 for EP2, etc.

Regards

Ekta

View solution in original post

0 Likes