May 13, 2021
06:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 13, 2021
06:31 PM
After power up, I need to wait 25mS in order to read data from the Flash correctly. Anything less then 25mS and I get data errors.
Is the datasheet correct is specifying 35uS for rising edge of Vcc/Vccio to rising edge of RESET#?
Thanks,
Tim
Solved! Go to Solution.
Labels
- Labels:
-
Memory Nor Flash
1 Solution
May 14, 2021
04:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 14, 2021
04:40 PM
Hello,
Thank you for contacting Cypress Technical Support, an Infineon Technologies.
It should be as in the datasheet. You maybe having your Vcc ramp very slow, but when it gets to 2.7V it should be 35uS.
Thank you
Regards,
Bushra
1 Reply
May 14, 2021
04:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 14, 2021
04:40 PM
Hello,
Thank you for contacting Cypress Technical Support, an Infineon Technologies.
It should be as in the datasheet. You maybe having your Vcc ramp very slow, but when it gets to 2.7V it should be 35uS.
Thank you
Regards,
Bushra