- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I use FPGA to operate flash devices S29GL01GP by writing buffer programing, the system can write 32 words in one programing operation. I intend to write 128K byte data to flash each time, the signal wave in figure write.
But when I read the data from the flash, I can only read first 32 words data. All other data are 0xffff. the signal wave in figure read. Who can tell me this write way is correct or not?
Thanks for your attention and answer !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
As per my understanding you are using write buffer programming method to program 128 KByte of memory, but you are able to read correct data from only the first 32 words. Is my understanding correct? If yes, could you please make sure you are following the steps mentioned in table "Write Buffer Program" in page 23 of the datasheet for each of the write buffer programming operation? Also, please provide waveforms for 2 different write operations.
Thanks and Regards,
Sudheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello
am also facing similar issue with s29glo1gp chip. am using this chip with p1021 procesor.
with flashcp am able to write only 2 bytes. if am giving more than 2 bytes , it is giving time out error.
Thanks for your attention and answer !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Chaitanya,
Are yo performing Write buffer programming ? Please tell me the order in which you are doing the write operation.
Can you please send us your code so that we can review and update you.
Thanks,
Krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Chaitanya,
When I say the order I mean, the sequence of operation as mentioned in the datasheet i.e two unlock cycles,Write Buffer Load Command and write word count.
Thanks.