- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HELLO
we are getting this error of flash timeout screenshot attached and in one
board nor flash is not coming out of CFI-ID mode
--
Thanks & Regards,
*Prabhjot kaur *
______________________________________________________________________________________
Logic Fruit Technologies | 806, 8th Floor, BPTP Park Centra, Sector - 30,
Gurgaon - 122001, Haryana.
E: prabhjot.kaur@logic-fruit.com | Web: http://www.logic-fruit.com
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Prabhjot kaur,
Please let us know the Cypress flash device that you use in your application.
Thanks and Regards,
Sudheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello
we are using S29GL512T11TFIV10 flash
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Prabhjot Kaur,
From the log messages I found that the error happens while performing a "write buffer programming operation". Could you please reset the error bits in status register using the below commands and try to program/erase again?
- Write Buffer Abort Reset command
- Status Register Clear command
Please read status register after issuing above commands to make sure the error bits are cleared.
Thanks and Regards,
Sudheesh