Sep 24, 2019
03:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2019
03:42 AM
Hi,
The data sheet lists the maximum SCK drive frequency.
The minimum drive frequency is described as DC (Don't Care).
If you want to drive the SPI from the bus master with SCK = 10kHZ, will there be any problems with the SPI operation?
Best Regards,
Harukawa
Solved! Go to Solution.
1 Solution
Sep 24, 2019
03:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2019
03:50 AM
Hi Harukawa san,
Operating frequency range for S25FL512S flash device is between 0Hz (DC) and FSCK(max)(as mentioned in datasheet).
e.g. As per datasheet minimum frequency for single SPI commands is DC (0Hz) and maximum is 133MHz. (Table 11 on page 31 of datasheet, https://www.cypress.com/file/177971/download )
It is OK to use FSCK = 10KHz in your application, it is within the datasheet limits.
Thanks and Regards,
Sudheesh
1 Reply