cancel
Showing results for 
Search instead for 
Did you mean: 

Non Volatile RAM (F-RAM & NVSRAM)

AlPa_3955366
New Contributor

This is a follow up to:

https://community.cypress.com/message/183373#183373

That discussion is locked now, no doubt because I disappeared. I'm back to being able to work on the problem again.

In that discussion, I told of my trouibles: I tried moving from the 64Kbit version to the 128Kbit version (FM25V01A) of the Cypress FRAM. I got no response from the FM25V01A, even though the SPI interface and the code I've written are essentially the same for both.


One suggestion was to read the ID or status register, but of course since there is no response on MISO, the problem remains.

Another suggestion was to show the power ramp up; the minimum according to the datasheet is 50 us/V. So, on 3.3V, I need at least 165 us. The attached image shows the analyzer's view of about 0.659 ms. Should be enough. Still no response on MISO.

Any other ideas for troubleshooting?

Thanks.

0 Likes
1 Reply
PradiptaB_11
Moderator
Moderator

Hi Alan,

Can you let us know how many devices are showing this issue.

Can you share with us the power up wave forms and also read ID or status register read wave forms.

Please check if SO is driven by device or not by connecting pull-up on SO pin. We need to check the wave forms to troubleshoot the issue.

Thanks,

Pradipta.

0 Likes