- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there application software available to load onto a target PSoC to help RF agency (FCC for example) testing?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If you are using PSoC 6 BLE, please find the attached project. This is a project similar to the PSoC 4 BLE’s integrated test code, where with a button press, the radio goes through different test modes required for FCC and most of RED testing.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please check the following KBA if you are looking for PSoC 4 BLE test firmware.
Test Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
to avoid the possible problem in sending more than 104 packets with the TXP command, I suggest replacing this loop instead of the wait function
//CyDelayUs(num_packets * UNIT_PACKET_TX_TIMEOUT);
for(int32_t i=0;i < num_packets;i++)
{
CyDelayUs(UNIT_PACKET_TX_TIMEOUT);
}
because the function CyDelayUs accepts an uint16 as a parameter.
Regards.
Oscar C.