- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
I would like to start working with CY8CPROTO-062-4343W to design a solution which reads analogue signal, converts it to digital and sends data to AWS using AFR.
I'm comfortable with the second part (sending data to AWS) as it is very well documented in the Getting Started Guide.
Could you please recommend a good entry point to get started with ADC on CY8CPROTO-062-4343W using ModusToolbox and Amazon FreeRTOS?
Solved! Go to Solution.
- Labels:
-
ispn:40047:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sergey,
An older version example to get you started with the project.:SAR ADC Modustoolbox
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sergey,
An older version example to get you started with the project.:SAR ADC Modustoolbox
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vasanth,
Thank you for your reply!
The example you referred to is for ModusToolbox 1.0. I'm using ModusToolbox 2.0 and it has quite a different project structure. It don't know how to convert this project from v1 to v2 or v2.1. Is it a relatively simple task? I have a lot of expertise with Eclipse, but I'm pretty new with ModusToolbox 2 and Cypress PSOC.
Best Regards,
Sergey