- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a design targeting a PSoC 4100S device, built in PSoC Creator 4.4. I'd like to migrate this design to ModusToolbox (v2.3.1), but as far as I can tell the device configurator does not support configuring the CAN peripheral on the PSoC 4100S device yet. I see there is a separate LIN configurator but I was unable to locate one for CAN. So I have two questions:
1. Is CAN configuration support planned for PSoC 4 devices in ModusToolbox?
2. In the meantime, I assume I can create my own peripheral driver for CAN to use in ModusToolbox. If I go this route, can I leverage the auto-generated CAN source files from PSoC Creator somehow, or do I need to write my own driver?
Solved! Go to Solution.
- Labels:
-
ModusToolbox General
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Currently, there is not support for CAN driver for that device.
We will update you once there is support for CAN driver for that device.
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Currently, there is not support for CAN driver for that device.
We will update you once there is support for CAN driver for that device.
Regards