- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I just installed ModusToolbox and was going step by step through the 101 tutorial "Blinky LED". I have the CY8CPROTO-063-BLE kit (which I selected from the list). I went to the device configurator to assign LED_RED to the right pin (P6.3 for this kit) but when I saved the configuration I got this message:
Personality 'ioss[0].port[0].pin[3] (LED_RED)' uses 'ioss[0].port[0].pin[3]' which does not exist on the device.
A little "spanner" icon gave me the possibility to fix this error by disabling ioss[0].port[0].pin[3] but then I got two new errors regarding SWDIO and SWDCLK...
I can't find any info on "ioss", how can I get rid of this error and move on to... blinking my LED...
Many thanks !
PS: Ports 6.4, 6.6 and 6.7 were activated by default when I opened the example file. There is nothing on Port 0 however.
Solved! Go to Solution.
- Labels:
-
ispn:40049:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
P0.3 is not available in this module, so you should disable the warning/error in ModusToolBox and choose to use other pins like P0.0(rename to RED_LED and config Strong drive mode) as LED drive pin.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
P0.3 is not available in this module, so you should disable the warning/error in ModusToolBox and choose to use other pins like P0.0(rename to RED_LED and config Strong drive mode) as LED drive pin.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oh that's strange, the first time I tried to disable it I got other error messages but not this time... I must have messed something else up the first time.
I had to upgrade KitProg2 to KitProg3 but the LED is blinking now, hooray my first PSoC application !
Thanks
PS: I assume P6.6 is for SWDIO, P6.7 for SWCLK but what is P6.4 for and where/how are these pins configured ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
P6[4] is a general IO pin, you can config any IO from IP Parameters Window.