cancel
Showing results for 
Search instead for 
Did you mean: 

ModusToolbox General

New Contributor

In the Modus project ,In addition to changing the code, is there any parameter configuration in modustool to change the flash start address of CM4.

Because I've changed the size of cm0 in my code, but I still can't change CM4. So I wonder if there are some operations on modustool that I haven't set.

0 Likes
Reply
1 Solution
Moderator
Moderator

Hello,

Can you please let me know which version of ModusToolbox you are using? From ModusToolbox 2.0 and above, we provide CM0p as a pre-built image and recommend all firmware development to be done on the CM4 CPU. However, we do offer some starter templates for dual-cpu usage which you can find here.

Regarding your question on how you can change the size of CM4, you can refer to the Section "Customizing Linker Scripts" in the following AN: https://www.cypress.com/documentation/application-notes/an215656-psoc-6-mcu-dual-cpu-system-design

Regards,

Dheeraj

View solution in original post

0 Likes
Reply
1 Reply
Moderator
Moderator

Hello,

Can you please let me know which version of ModusToolbox you are using? From ModusToolbox 2.0 and above, we provide CM0p as a pre-built image and recommend all firmware development to be done on the CM4 CPU. However, we do offer some starter templates for dual-cpu usage which you can find here.

Regarding your question on how you can change the size of CM4, you can refer to the Section "Customizing Linker Scripts" in the following AN: https://www.cypress.com/documentation/application-notes/an215656-psoc-6-mcu-dual-cpu-system-design

Regards,

Dheeraj

View solution in original post

0 Likes
Reply
Top labels