- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can the CYBT-213043-MESH eval kit be debugged using a miniprog4? If so where do you connect the miniprog 4?
Solved! Go to Solution.
- Tags:
- ble mesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer the below document for general information about Hardware Debugging.
https://github.com/Infineon/btsdk-docs/blob/master/docs/BT-SDK/WICED-Hardware-Debugging.pdf
Please use P13 as SWDIO and P12 as SWDCK in mesh kit. You can get this information from spar_utils.h
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer the below document for general information about Hardware Debugging.
https://github.com/Infineon/btsdk-docs/blob/master/docs/BT-SDK/WICED-Hardware-Debugging.pdf
Please use P13 as SWDIO and P12 as SWDCK in mesh kit. You can get this information from spar_utils.h
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you. This is the information that was needed.