- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
We are developing CYBT-483056-02 with MTB2.2.
On CYBT-483039-02 with CYW20719B1, it was necessary to add the following settings in WICED.
Do I need to make similar settings when developing CYBT-483056-02 with MTB?
Should I set the output setting of CYW20719B2 to -2dBm (because PA / LNA is 22dBm) in order to obtain POUT of 20dBm?
Best regards,
TK
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi TK,
I am checking this internally. Apologies for the delay. Will post answer for your queries asap.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is there an update?
Best regards,
TK
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The background to this question is as follows.
-In the design using CYBT-483039-02 (CYW20719B1) and WICED, it was possible to connect to the opposite terminal.
At that time, PA / LNA is enabled according to the following.
-Using CYBT-483056-02 (CYW20719B2) and MTB, the above PA / LNA is also enabled, but I cannot connect to the opposite terminal.
When I check the RSSI, there are variations, and I'm guessing that PA / LNA is not enabled.
Please tell me how to operate normally with the combination of CYBT-483056-02 and MTB.
Best regards,
TK
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This issue is handled in a technical case.