- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
When four CYBT-213043-02 are connected to USB port(via USB hub), it's quite boring to program them.
The program configuration find first card and program it.
Thus, once a particular card is programmed, it must be disconnected from the USB so that the program configuration can program the next.
Does exist some workaround ?
Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In MTB 2.0, you can select the HCI port in the makefile. In the following app features/defaults, change the UART?=AUTO to UART?=COMxx, where COMxx is the HCI port for the target board.
Please notice that you need to do a clean before download to each board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For Modus1.1, you can choose the UART port by "project -> change application settings" and then set the UART port from "AUTO" to the number of the HCI port.
For Modus2.0, I am checking internally to see how to set the HCI port.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you find a solution for 2.0 ?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In MTB 2.0, you can select the HCI port in the makefile. In the following app features/defaults, change the UART?=AUTO to UART?=COMxx, where COMxx is the HCI port for the target board.
Please notice that you need to do a clean before download to each board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks.
Probably there is more convenient method, allowing to specify COM port on-the-fly, e.g. from command line.
If YES, what is the syntax of such instruction.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry, this is the only way to specify the HCI port currently.