CYBT-343026-01 show different current on both board.

[NeDh_4602711]

Hello,

I have just written wiced_sleep_config(WICED_TRUE, NULL, NULL) in code and I am getting 2 different reading of both board

This the board given by local Cypress vendor

All LEDs are disconnected. This board gives current 0.1 mA and now when I tried on my board

It shows 12.3 mA current. Nothing else is connected. Also I have confirmed that code is successfully programmed by using PUART.

Why so? I am checking current across VDDIN line. Nothing is else is connected in both board. Is there anything that I am missing to connect or something else?

Where I am wrong?

Thanks and regards

@NeerajDhekale

[DheerajPK_41]

Hi,

May I know in which power mode the devices are running?

Also the device configuration (eg. Peripheral access) and other conditions while measuring the current?

Please make sure the initial conditions are same before measuring the current.

You can measure the current across VDDIN. In case the EVAL board you can use the Jumper J2.

Thanks,

-Dheeraj

[NeDh_4602711 · Accepted solution]

Hello

there was a problem with the controller. I tried replacing the controller and it works.

Thanks and regards

Neeraj

[DheerajPK_41]

Thank you very much NeDh_4602711  for sharing the information with us.