cancel
Showing results for 
Search instead for 
Did you mean: 

ModusToolbox Bluetooth SDK

NeDh_4602711
Contributor II

Hello,

I have just written wiced_sleep_config(WICED_TRUE, NULL, NULL) in code and I am getting 2 different reading of both board

This the board given by local Cypress vendor
2DF23783-1205-4A79-BBFB-EB902DD7D4D4.jpeg
All LEDs are disconnected. This board gives current 0.1 mA and now when I tried on my board

52461B6E-EF01-4A93-8734-D56EB8F652E3.jpeg
It shows 12.3 mA current. Nothing else is connected. Also I have confirmed that code is successfully programmed by using PUART.

Why so? I am checking current across VDDIN line. Nothing is else is connected in both board. Is there anything that I am missing to connect or something else?

Where I am wrong?

Thanks and regards

@NeerajDhekale

0 Likes
1 Solution
NeDh_4602711
Contributor II

Hello

there was a problem with the controller. I tried replacing the controller and it works.

Thanks and regards

Neeraj

View solution in original post

3 Replies
DheerajPK_41
Moderator
Moderator

Hi,

May I know in which power mode the devices are running?

Also the device configuration (eg. Peripheral access) and other conditions while measuring the current?

Please make sure the initial conditions are same before measuring the current.

You can measure the current across VDDIN. In case the EVAL board you can use the Jumper J2.

Thanks,

-Dheeraj

0 Likes
NeDh_4602711
Contributor II

Hello

there was a problem with the controller. I tried replacing the controller and it works.

Thanks and regards

Neeraj

View solution in original post

DheerajPK_41
Moderator
Moderator

Thank you very much NeDh_4602711  for sharing the information with us.

0 Likes