CWY20819 park and hold mode Level 4 ToKo_4602001 Level 4 Sep 17, 2020 10:26 PM Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Report Inappropriate Content Sep 17, 2020 10:26 PM Jump to solution wiced_bt_dev_set_sniff_mode() is provided for SNIFF mode.However about park mode and hold mode, I cannot find the API to enter out product into these mode.Is it possible to use park and hold?Regards, Solved! Go to Solution. 0 Likes Reply Subscribe 1 Solution Re: CWY20819 park and hold mode Moderator AnjanaM_61 Moderator Sep 21, 2020 09:30 PM Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Report Inappropriate Content Sep 21, 2020 09:30 PM Jump to solution Hi ToKo_4602001 ,Only Sniff and Sniff subrating are supported – See APIs below. Park/Hold – Not supported. Park has been removed from the BT spec in BT 5.0.Regards,Anjana View solution in original post 1 Like Reply All forum topics Previous Topic Next Topic 2 Replies Re: CWY20819 park and hold mode Moderator AnjanaM_61 Moderator Sep 21, 2020 09:30 PM Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Report Inappropriate Content Sep 21, 2020 09:30 PM Jump to solution Hi ToKo_4602001 ,Only Sniff and Sniff subrating are supported – See APIs below. Park/Hold – Not supported. Park has been removed from the BT spec in BT 5.0.Regards,Anjana 1 Like Reply Re: CWY20819 park and hold mode Level 4 ToKo_4602001 Level 4 In response to AnjanaM_61 Sep 22, 2020 04:51 PM Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Report Inappropriate Content Sep 22, 2020 04:51 PM Jump to solution Thank you for your answer. 0 Likes Reply Post Reply
