Microcontrollers Forum Discussions

Hi members,

I have a question about How can I erase SMU ALM7[7].

This Alarm is related to the SPU Module, However, in this IC, There is no SPU Module. 

So I wonder why this alarm is activated and How can I erase this alarm.

Every time I turn on this IC, the alarm is set to 0x1.

And I tried to clear All the Alarm, but Alram 7[7] was always High. 

please let me know that. 

Thank you.

Im using tc377 for uart communication, I have to send data from tx  without interrupt by using Timer(Gpt12)
when i using this Data is stored in Tx buffer but not transmitting to Rx. 

This is timer function
void interruptGpt12_T3(void)
{
IfxCpu_disableInterrupts();
IfxPort_togglePin(LED);
if(g_flag1 == 1)
{

send_receive_ASCLIN_UART_message();
}

IfxGpt12_T3_setTimerValue(&MODULE_GPT120, RELOAD_VALUE_T3);
IfxCpu_enableInterrupts();
}

This one data transfer and receive function through uart
extern void send_receive_ASCLIN_UART_message(void)
{

IfxAsclin_Asc_write(&g_ascHandle, g_txData, &g_count, TIME_INFINITE); /* Transmit data via TX */
IfxAsclin_Asc_read(&g_ascHandle, g_rxData, &g_count, TIME_INFINITE); /* Receive data via RX */
}

Hi, I can't add any printf or can't use UART from sample Ethernet application

if I add anything there it is crashing

I need to process data after receiving from Ethernet but if I try to do anything application just crash. So how and where to process Ethernet data. 

Hi, I am using Aurix TC375 Lite Kit development board and tried the freeRtos example code.

But after compilation, once the code is put in the debugger mode then the tsim issue comes as below snapshot --

Please get me a solution for this issue asap.

Thanks.

I am attempting to follow the "Secure Boot" SDK user guide but continually run into the same problem. When attempting to setup the "CySecureTools" workspace i get the same error 'bash: cysecuretools: command not found' i get this even though i installed it and when i attempt to reinstall  cysecuretools i got the message stating command already satisfied.  This is all done on Windows. 

I am using Application Kit TC3X7 V2.0 TFT board

I have configured BMHD but  the board all the time boots from Internal flash ignoring BMHD settings

If i want to use Alternate Boot Mode or BMI  to boot , which all changes i need to do on the board?

Hi,

I am using CY8C6245LQI-S3D42 and I used the DFU examples to boot the system and created the application to run on AM4 core and everything is working well. 

I wait for 5 sec in DFU to check if there is any updates or just move with the Application code.

I find that sometimes the device stops booting once in a blue moon. Now If I flash again just the boot loader, everything is fine , I need not have to write the Application, it moves from DFU in 5 sec to application.

I believe, there is some how the flash/DFU is getting corrupted.  I want to protect this scenario. Can some one share how do I protect my DFU so that it never erases . Any example's will be appreciable, I am using USB CDC transport in DFU.

Regards,

Madhav