S6BT112A Power-on Sequence NSLP permanently High

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
acsi_4349416
Level 1
Level 1
First question asked Welcome!

Hello,

I'm working on a S6BT112A design without a MCU and can therefore not simply delay the rise of NSLP on Power-On.

Would it be a valid design to connect NSLP permanently to +5V?

Would this put the S6BT112A into Normal Mode after Power On?

+5V would be available sooner to the circuit than V_Bat, could this be an issue if the NSLP & SELMS Pins are driven high before the Bat Pin is powered?

Here is a quick illustration of my intended circuit.

rect3280.png

Best Regards

Achim

0 Likes
1 Solution

Hello

We think your intended circuit can work normally.

Thanks

Cypress) Kuninaka

View solution in original post

0 Likes
2 Replies
SadaharuK_26
Employee
Employee
Welcome! First solution authored First reply posted

Hello

We are confirming it, please wait a moment.

Thanks

Kuninaka

0 Likes

Hello

We think your intended circuit can work normally.

Thanks

Cypress) Kuninaka

0 Likes