cancel
Showing results for 
Search instead for 
Did you mean: 

Legacy Products

Anonymous
Not applicable

Hi All ,

We used this controller in one of the our project, in that we faced one issue .

We are not able to flash the code in the controller. So i need to cross verify the procedure with what you have already.

So i am expecting user manual to flash the code as well as evaluation board schematic to ensure the hardware connection.

The attached file have the MCU page , in that we used the following signals to flash the image.

Pin nameFlashing Points
MDJ1105
RSTX
J1111
VCC
J1106
GND
J1107
DEBUG_IFJ1101
SIN0
J1103
SOT0
J1104
SCK0
J1102

Regards,

Selvakumar S

0 Likes
Reply
1 Solution
Moderator
Moderator

Were you using Flash Programmer for 16FX (via UART)? You can find the user manual (PCW16FXe.pdf) in the package.

http://www.cypress.com/documentation/software-and-drivers/flash-mcu-programmer-1

Best regards,

Amy Wang

View solution in original post

0 Likes
Reply
1 Reply
Moderator
Moderator

Were you using Flash Programmer for 16FX (via UART)? You can find the user manual (PCW16FXe.pdf) in the package.

http://www.cypress.com/documentation/software-and-drivers/flash-mcu-programmer-1

Best regards,

Amy Wang

View solution in original post

0 Likes
Reply
Top labels