- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All ,
We used this controller in one of the our project, in that we faced one issue .
We are not able to flash the code in the controller. So i need to cross verify the procedure with what you have already.
So i am expecting user manual to flash the code as well as evaluation board schematic to ensure the hardware connection.
The attached file have the MCU page , in that we used the following signals to flash the image.
Pin name | Flashing Points | |
---|---|---|
MD | J1105 | |
| J1111 | |
| J1106 | |
| J1107 | |
DEBUG_IF | J1101 | |
| J1103 | |
| J1104 | |
| J1102 | |
Regards,
Selvakumar S
Solved! Go to Solution.
- Labels:
-
Other Legacy MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Were you using Flash Programmer for 16FX (via UART)? You can find the user manual (PCW16FXe.pdf) in the package.
http://www.cypress.com/documentation/software-and-drivers/flash-mcu-programmer-1
Best regards,
Amy Wang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Were you using Flash Programmer for 16FX (via UART)? You can find the user manual (PCW16FXe.pdf) in the package.
http://www.cypress.com/documentation/software-and-drivers/flash-mcu-programmer-1
Best regards,
Amy Wang