Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
VCCIO/VDDD電源が2V以下の場合、VCCDをVCCIO/VDDDに接続してください。デバイス構成がUSB-シリアル構成ユーティリティを使用している場合、VDDDが2V未満であることも選択する必要があります。詳細は、構成ユーティリティユーザーガイドの184.108.40.206.2章の「VDD is less than 2 V」を参照してください。USB-シリアルソフトウェアページから構成ユーティリティとユーザーガイドをダウンロードできます。
Question: Is it possible to use CYUSB3KIT-003 as a self-powered device?
Answer: In the current CYUSB3KIT-003 hardware design, the VBATT pin of FX3, used to operate the device in self-power mode, is NC. Since the VBATT pin is not brought out on to the kit, CYUSB3KIT-003 cannot be used as a self-powered device.
How do I cause re-enumeration of FX3/CX3/FX3S after programming to SPI flash or I2C EEPROM using the Control Center application without pressing the reset button or disconnecting the device physically?
Using the Control Center application, programming a firmware image into I2C EEPROM or SPI Flash is done as shown below:
Once I2C EEPROM or SPI flash is selected, the FX3 Bootloader device comes up as ‘Cypress FX3 USB BootProgrammer Device’ and prompts the user to select the firmware image to download into EEPROM or flash as shown below:
Once the firmware download is done, FX3 needs a cold reset to boot from the new image downloaded into EEPROM or flash. Pressing the reset button or power cycling the board causes FX3 to boot from the new firmware (if PMODE pins are set as required).
FX3 cold reset can also be achieved by issuing the 0xE0 vendor command from the BootProgrammer Device as follows:
After control center shows the message: “Programming of I2C EEPROM Succeeded” or “Programming of SPI FLASH Succeeded”, issue the 0xE0 vendor command as shown below:
Figure 1: Vendor command usage in control center
If the PMODE pins of FX3 are set either to 1ZZ or Z1Z, the device will re-enumerate with the new firmware from the EEPROM or flash respectively or fall back to USB and enumerate as a ‘Cypress FX3 USB Bootloader Device’ if there are any issues with the new firmware.