Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.

Knowledge Base Articles

cancel
Showing results for 
Search instead for 
Did you mean: 
Create an article

Knowledge Base Articles

Recent documents

Sort by:
Chelladurai
Knowledge Base Articles
Version: ** Is the XENSIVTM PAS CO2 sensor affected by acoustic and vibration noise?XENSIVTM PAS CO2 sensor has a robust packaging, and is acoustica... Show More
Chelladurai
Knowledge Base Articles
Version: ** Watchdog timer (WDT) setting is configured with the following three options when the debugger is connected:   - Counter is stopped when a... Show More
Chelladurai
Knowledge Base Articles
Version: ** ContextDetermine the default setting of the watchdog timer (WDT) at power-on. SolutionTRAVEO™ T2G has two WDTs: basic WDT and multi-count... Show More
Chelladurai
Knowledge Base Articles
Unexpected debugger disconnection during program execution in TRAVEO™ T2G – KBA233857 Version: ** Solution: Check if the following operations are per... Show More
ArunKumarChoul
Knowledge Base Articles
Version: ** Question: What needs to be checked if JTAG debugger is not connected? Answer: If the signal quality of the hardware is not good, do the f... Show More
ArunKumarChoul
Knowledge Base Articles
Version: ** Question: How do I evaluate the impact of PLL jitter on CAN precision when PLL clock is used for a CAN peripheral? Answer: Use the follow... Show More
ArunKumarChoul
Knowledge Base Articles
Version: ** Question: How do I clear the watchdog timer (WDT) in Sleep mode for TRAVEOä II family MCU? Answer: The WDT cannot be cleared in Sleep or ... Show More
ArunKumarChoul
Knowledge Base Articles
Version: ** Question:What is the thermal resistance for TRAVEOä II CYT2B series? Answer: The thermal parameters (ƟJa, ƟJB, ƟJc) used to characterize ... Show More
ArunKumarChoul
Knowledge Base Articles
Version: ** Question: Is it possible to use a combination of two different sizes of data fields for buffers/FIFO elements of the CAN FD Controller? ... Show More
ArunKumarChoul
Knowledge Base Articles
Version: ** Question: How can I get the CPU board to operate only at 3.3 V? Answer: Ensure that the jumper settings are as follows: J23: Short bet... Show More