cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

Utilization of the Unused GPIF Control Lines - KBA83964

Anonymous
Not applicable

Utilization of the Unused GPIF Control Lines - KBA83964

Version: *A

Translation - Japanese: 未使用GPIFコントロールラインの活用 - KBA83964 - Community Translated (JA)

Question:

Does triggering of the GPIF change the state of the unused control lines?

Answer:

No, triggering of the GPIF does not change the state of the unused control lines. This is an advantage in a situation when we are using only a few of the GPIF control lines. Let us say, of the 6 available control lines, we are using only 2 for GPIF and the rest 4 can be used for other purposes. When the GPIF is idle, we can manipulate (enable and drive a value) the state of the unused 4 control lines using the GPIFIDLECTL register. Even when the GPIF is triggered, the unused control lines will retain the value they were initialized to in the GPIFIDLECTL register.

1.png

Note: TRICTL is the 7th bit of the register GPIFCTLCFG which indicates the number of active outputs/tri-stating

Version history
Revision #:
1 of 1
Last update:
‎Sep 15, 2009 05:55 AM
Updated by:
Anonymous
 
Contributors