Using CPU Board at 3.3 V in Traveo II Body Entry - KBA232819
Employee
Mar 31, 2021
12:43 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Mar 31, 2021
12:43 AM
Version: **
Question:
How can I get the CPU board to operate only at 3.3 V?
Answer:
Ensure that the jumper settings are as follows:
- J23: Short between pin2 and pin3 (The 3.3 V power rail on the board is enabled).
- J9: Open between pin1 and pin2 (Power-on-reset for +5 V is disabled).
For more information, see the documentation available with the CYTVII-B-E-1M-176-CPU evaluation board.
Note: This KBA applies to the following series of Traveo II MCUs:
- Traveo II for Body CYT2B7 Series
Labels
Rate this article: