cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

Unexpected debugger disconnection during program execution in TRAVEO™ T2G – KBA233857

Chelladurai
Community Manager
Community Manager

Unexpected debugger disconnection during program execution in TRAVEO™ T2G – KBA233857

Unexpected debugger disconnection during program execution in TRAVEO™ T2G – KBA233857

Version: **

Solution:

Check if the following operations are performed:

- Check if the JTAG / SWD port has been changed to anything other than JTAG / SWD in the Port settings.

- Check if the following Debug Access Port settings (Disable) are correct.

- CPUSS_AP_CTL register1:

   DISABLE bit (where xxx can be CM0 or CM4, or SYS)

            ENABLE bit (where xxx can be CM0 or CM4, or SYS)

Note: This KBA applies to the following series of TRAVEO™ T2G MCUs:

  • CYT2 series
  • CYT3 series
  • CYT4 series

1 For details, refer to "DAP Security" section of the architecture TRM and the "CPUSS_AP_CTL" register of the registers TRM.

0 Likes
Version history
Revision #:
1 of 1
Last update:
‎Sep 12, 2021 11:52 PM
Updated by:
 
Contributors