USB to SD throughput with EZ-PD FX3S, EZ-PD SD3, or EZ-PD SD2 – KBA233245
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Community Translation: EZ-PD FX3S、EZ-PD SD3、またはEZ-PD SD2を用いたUSBからSDへのスループット – KBA233245
Version: **
Question: What is the throughput of USB to SD card that can be achieved using EZ-PD™ FX3S, EZ-PD SD3, or EZ-PD SD2?
Answer: For each storage port, the theoretical data rate can be calculated as follows:
Data rate (MBps): SD_CLK frequency * data bus width/8
The maximum throughput is achieved under the following conditions:
1. |
Device used for testing |
FX3S |
2. |
SD card |
SanDisk SD1N5C4 eMMC 4.41 |
3. |
SD bus width |
8 bits |
4. |
MMC Clock Frequency |
52 MHz (DDR mode) |
4. |
Driver |
Windows Mass Storage Device |
USB – SD Performance
USB Speed |
Read (MBps) |
Write (MBps) |
USB 3.0 |
44.5 |
49.6 |
USB 2.0 |
30.2 |
24.1 |
The standard Windows Mass Storage driver uses very small bursts (64 KB) for mass storage data transfers, and the performance obtained is limited by various protocol overheads.
For the performance of EZ-PD FX3S with RAID 1 firmware, see section 8 of AN89661.
- Tags:
- fx3s
- sd2
- sd3
- throughput