USB-to-Parallel Converter Using EZ-USB® FX2LP™ – KBA88219
Anonymous
Not applicable
Mar 10, 2014
01:43 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Mar 10, 2014
01:43 AM
Version: **
Translation - Japanese: EZ-USB®FX2LP™を使用したUSB-パラレルコンバーター – KBA88219 - Community Translated (JA)
Question: How can you use EZ-USB® FX2LP™ to make a USB-to-parallel converter? The data received over the USB should be made available on a parallel data bus on the GPIO pins.
Answer:
There are two methods to implement a USB-to-parallel interface in FX2LP.
- The GPIF or slave FIFO mode of FX2LP can be used, depending on the external device that is being interfaced with FX2LP.
- Without using the GPIF or slave FIFO interface, firmware can be written to implement the same using the 8051 core.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous