USB peripheral with the CY7C63743 that uses the capture timers
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: What is the configuration for the Capture Timer input pins: resistive or Hi-Z ?
Answer:
The Capture Timer input pins should be set to Hi Z mode.
Note: M8 series and enCoRe USB low speed peripherals are not recommended for new USB low speed designs. Instead please use our encore II USB low speed peripherals for new applications.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous