Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Question: How do you connect the RESET pin of the USB-Serial Bridge Controller device?
The RESET pin of a USB-Serial Bridge Controller device is an active LOW signal with an internal pull-up resistor connected to the VCCIO supply (for CY7C65213) or the VDDD supply (for CY7C65211 and CY7C65215). The RESET line can be left floating as there is already an internal pull-up resistor. If you want to use an external pull-up resistor on the RESET line, a 1KΩ external pull-up resistor connected to the VCCIO/VDDD supply is recommended. However, if you want to use a separate external voltage source to pull up the RESET line, please ensure that the voltage applied on the RESET pin is equal to or less than the VCCIO/VDDD voltage.