USB Bootloader HOST program for enCoRe III and enCore V
Anonymous
Not applicable
Oct 14, 2011
02:55 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Oct 14, 2011
02:55 AM
Question: Is there a sample HOST program to boot load my USB device?
Answer:
Cypress Bootloader Host program is available in the PSoC Programmer installation folder. (default location : C:\Program Files\Cypress\Programmer\3.13\Bootloaders\BootLoaderUSBFS\USB_BootloaderHostApp\PSoC Config_1_0_0_3).
Please note that this Host Application is coded to detect only the bootloader configurations with VID/PID set to 04B4/E006. Hence you are required to modify the USB Bootloader module for this VID/PID inorder to use this sample program
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous