Community Translation: TRAVEO™ T2G: デバッガーの接続時に WDT 設定を構成する - KBA233927
Version: **
Watchdog timer (WDT) setting is configured with the following three options when the debugger is connected:
- Counter is stopped when a debugger is connected.
- Counter is stopped only when a debugger is connected and the CPU is halted during
a breakpoint.
- Counter is running when debugger is connected. No reset is issued when the CPU is halted during
a breakpoint but the counter is not stopped.
Note that in each case, no reset and no FAULT is issued when the debugger is connected to the target system.
For details, see "Debug mode" in the WDT section of the TRM.
Note: This KBA applies to the CYT2, CYT3, and CYT4 series of TRAVEO™ T2G MCUs.
