Switching I2C compatible bus frequency on the CY3671 dev kit
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: How to switch I2C compatible bus frequency on the CY3671 dev kit?
Answer:
To change the speed of the I2C compatible bus you use the I2CMODE register bit 0. If you are using version 1.2 of the Technical Reference Manual it may not be as clear. In one section it has the bit as a 0-read only. It is r/w and is called 400KHZ. The EEPROM configuration bit is stored in this bit. If you change the bit, the bus rate should also be changed.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous