Programming Cypress' M8 family of parts
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: How do I program Cypress' M8 family of parts?
Answer:
For low volume, Cypress recommends using its CY3649 HiLo programmer. The programmer base unit is all that is required to program the CY7C630xx family parts. However all other Cypress M8 parts will require an additional adaptor base and matrix card specific to the part.
Please refer to the website or your local Cypress Sales Representative for further information on ordering the programer and locating the correct adaptor base and matrix card.
Many 3rd party programmers support gang programming for our M8 parts as well.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous