Attachments are accessible only for community members.
Platform and New Patch Files For 20719B1 in WICED 6.4.0.61
Employee
Jul 01, 2020
02:04 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jul 01, 2020
02:04 AM
How to make 20719B1 modules, including: 423028, 413034, 483039, available in WICED® Studio 6.4.0.61 SDK?
Follow this step-by-step article to make mentioned modules available in WICED® Studio 6.4.0.61 SDK:
-
When downloading WICED 6.4.0.61 from the Infineon Community, do not download config.eml. This configuration file does not include all module platforms. Instead, use the config.eml file available with this knowledge base article (KBA).
-
Place config.eml and WICED-Studio-6.4.0.61-IDE-Installer.exe in the same folder, and run the exe.
-
After the installation is complete, replace the patch files in WICED-Studio-6.4.0.61\20719-B1_Bluetooth\WICED\internal\20719B1 with the new patches available with this KBA.
The following is a sample make target to build a project in WICED Studio 6.4.0.61 for the CYBT-423028 evaluation kit:
demo.hello_sensor-CYBT_423028_EVAL download
Do the following if you encounter a firmware download failure:
-
Verify that the USB-UART driver is correctly installed.
-
Verify that SW4 switches are in ON position (CTS, RTS, RXD, and TXD)
-
Power-cycle CYBT-423028-EVAL and retry.
If this problem persists, the serial flash on the board may be corrupted. Do the following to reset CYBT-423028-EVAL board to factory default state.
Note: This will erase any user application in the memory and reset the board to the default state.
-
Press and hold the RECOVER button (SW2).
-
Press and hold the RESET button (SW1) for 1 second.
-
Release SW1.
-
Release SW2.
-
Re-program CYBT-423028-EVAL.
Author: HaiY_26 Version: **
Labels
Rate this article: