Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Part Number for the MiniProg1 target connector, 5-pin ISSP header in Miniprog3
Question: What is the part number of target connector for Miniprog1, 5-pin header in Miniprog3?
The 5-pin connector in Miniprog1, Miniprog3 is used to program PSoC 1 devices using the In-System Serial Programming (ISSP) interface. ISSP is a Cypress legacy interface used to program the PSoC1 family of microcontrollers.The 5-pin connector in Miniprog1, Miniprog 3 is configured as a single row with 100 mil pitch. It is designed to mate with a Molex model 22-23-2051 straight male header (Digi-Key Part Number WM4203-ND), or 22-05-3051 right angle (Digi-Key Part Number WM4303-ND) male header , with key tab. The signal assignment is shown in figure below. It must be noted that MiniProg3 supports programming of PSoC1 devices using the 5-pin connector only. The 10pin connector in Miniprog3 does not support ISSP interface.