PLT and CYFISNP user modules resource conflict
Anonymous
Not applicable
Sep 01, 2011
03:28 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Sep 01, 2011
03:28 PM
Question: I can’t place the PLT and CYFISNP user modules in the same configuration. I receive a message “Unable to place CYFISNP User Module because of current resource allocation”. How do I use these two modules together?
Answer:
To use the PLT and CYFISNP user modules on the same device, you must use dynamic reconfiguration, which means the user modules will be loaded at different times based on the need for using one form of communication or the other. For a description of how to use dynamic reconfiguration, refer to the application note AN2104 “PSoC Dynamic Reconfiguration”.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous