Modify registers using the A0 vendor request through the EZ-USB Control Panel
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: I am using the AN2131DK-001. Is it possible to modify registers using the A0 vendor request through the EZ-USB Control Panel?
Answer:
The A0 command can only do read and writes to internal RAM memory. It cannot modify the registers.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous