Known Limitations with CY4531/CY4541 EVKs Based on CCG EVK Baseboard Rev 04 or Earlier - KBA212600
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Version: *A
Translation - Japanese: Rev 04 またはそれ以前の CCG EVK ベース基板をベースとした CY4531/CY4541 EVKで既知の制約について - KBA212600 - Community Translated ...
Question:
What are the known limitations with the CY4541/CY4531 EVKs which are based on Revision 04 or earlier of the CCG EVK baseboard?
Answer:
Limitation 1: The VBUS voltage may drop below vSrcNew* when a peer device draws more than 3 A on a Type-C port.
Workaround: It is recommended to restrict the maximum sink current to 3 A.
Limitation 2: During voltage transitions (for example going from 5 V to 9 V or vice-versa), the overshoot and undershoot on VBUS may exceed the max and min limits of vSrcValid* by up to 10%.
Workaround: None
* Refer to Table 7-22, Source Electrical Parameters of USB Power Delivery Specification, Revision 2.0, Version 1.1 for more details
Note 1: These limitations got fixed in the Revision 05 of the CCG EVK baseboard. Hence they are not applicable on the CY4531/CY4541 EVKs which are based on CCG EVK baseboard, Revision 05 or higher.
Note 2: The Revision number of the CCG EVK baseboard can be found on the PCBA as shown in Figure 1.
Figure 1. Identifying board revision number
Contact Cypress Technical Support cytechsupport@cypress.com for additional details.
- Tags:
- usb controllers
-
This widget could not be displayed.Anonymous