JTAG nTRST Pin Termination in Traveo S6J3XXX Series - KBA219205
Anonymous
Not applicable
Apr 10, 2017
11:06 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Apr 10, 2017
11:06 PM
Version: *A
Translation - Japanese: Traveo S6J3XXXシリーズのJTAG nTRSTピン終端 - KBA219205 - Community Translated (JA)
Question:
How should the nTRST pin of JTAG be terminated on the PCB?
Answer:
It is recommended to leave the nTRST pin OPEN. There is no need to terminate by pull-up or pull-down because the nTRST pin is pulled down in the Traveo™ MCU. The recommended diagram is shown below.
Note:
This KBA applies to the following series of Traveo MCUs:
- S6J3110
- S6J3120
- S6J3200
- S6J3300
- S6J3350
- S6J3360
- S6J3370
- S6J3400
- S6J3510
Labels
Rate this article: