Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Issues with Pins Locked to a Certain Level Despite Simulation
Question: 1.I have a pin that is unresponsive despite all attempts to drive the signal? 2.The functional simulation shows that it should work, but it doesn't. Help?
Issues of this kind usually result from issues that are not related to the software code. This situation often occurs when the device was improperly programmed. Please check the length of the ISR cable being used to program the device. If the cable and ribbon put together is longer than 6 feet, the problem may be in the fact that the PC is unable to drive a coherent signal over the length of the cable. Another thing to check for is to see if the JTAGen pin is toggled properly after programming has completed.
Please be noted our entire Cypress CPLD product are Obsolete and not recommended for new design and development. For more information on CPLD product, please visit our webpage:http://www.cypress.com/go/cpld